Many people may be unfamiliar with the material of PE pipe, but the PE among them is polyethylene plastic. When it comes to the application of this product in daily life, everyone will be very familiar with it, such as the plastic wrap and plastic ba...
The design of the Lotion Pump is also constantly innovating. From the early plastic cover and squeeze cover to the later spray pump, each time is to better store cosmetics and facilitate people's use. So what we mainly understand today is the advanta...
Rubber Rings Manufacturers introduce a good way to remove rubber smell: 1. If there are some products made of rubber indoors, the best and easiest way to remove the smell is to open the windows for ventilation, or directly put the rubber products out...
Overheating of the Pe Gasket is usually caused by the unfavorable conditions of excessive heat generation of the sealing surfaces of the centrifugal pump. Teflon O-rings turn blue or black, and O-rings harden and crack. The condition near the sealing...
Storage conditions for Rubber Rings : 1. Temperature: 5-25℃ is the ideal storage temperature. Avoid exposure to heat and sunlight. Seals taken out from low-temperature storage should be placed in an environment of 20°C before use. 2. Humidity: The re...
The part of Pe Gasket between the connector and the nut is generally a flat metal ring. Next, let's take a look at the material classification of Pe Gasket? 1. Non-metallic gaskets: gaskets made of non-metallic materials such as asbestos, rubber, syn...
Plastic balls are suitable for making various industrial, agricultural, and civil plastic products. For example, polyethylene film has been widely used as packaging bags for various foods and medicines. Polyvinyl chloride film has been widely used as...
Rubber Rings Manufacturers introduced that when selecting the compression rate of O-rings, the following three aspects should be considered: 1. There must be enough sealing contact area; 2. Friction as small as possible; 3. Try to avoid deformation. ...
Reasons for PE Gasket Failure: 1. The uneven pressing force is caused by many factors. The first is the human factor. Asymmetrical preloading of bolts during construction can easily cause unevenness. This factor can be eliminated during construction....
Polishing production process of Plastic Balls : 1. Design and develop plastic balls and plastic ball molds, arrange them reasonably, calculate the shrinkage rate of plastic balls and plastic balls, and control the roundness of plastic balls when prod...
Matters needing attention in the use of Rubber Rings : 1. Before installation, check the quality of the pipe fittings and rubber sealing ring, clean the dirt on the socket and the socket, and then install the rubber ring in the socket groove without ...
How to scientifically improve the service life of Pe Tubes : 1. It is the main raw material. The top domestic PE raw materials can basically achieve anti-aging for 50 years. However, due to the different needs of customers, not many PE pipes are made...
Login
Mob : +86-13484228840
Tel : +86-0574-62030456
E-mail :